Our Solar Security Camera ONLY works with 2.4Ghz WiFi, not works with 5Ghz WiFi. 

This wireless CCTV camera doesn't support 24/7 continuously recording. It comes with PIR Motion Recording, only records video when motion detected. 

It will NOT track the moving objects when motion detected. Just APP notifications push, spotlights and siren alarms, depend on your settings. 

Yes, you can add multi security cameras on the app. Also you can view 4 cameras at same time. 

The battery can last about 3 months (If motion detection trigger about 15 times per day ) after each full recharge. The fewer times the alarm is triggered, the battery lasts longer. 

"If the PIR is accidentally triggered, there may be objects in the motion detection area that can easily set off the alarm, such as an air conditioner running or a car. Solution: 1. it is recommended not to install the camera on the side of the road or in crowded scenes. 2. try not to point the camera at a heat source similar to the outdoor unit of the air conditioner to avoid accidental triggering. 3. adjust the sensitivity of the motion detection and reduce the motion detection range of the camera. 4. the alarm schedule can be adjusted and the time period of the camera alarm can be divided reasonably." 

1. the noise generated by the intercom is generally caused by close range operation and the camera and speaker equipment cannot be brought too close. 2. the recording distance set by the camera is farther and the sensitivity is higher, and it is easy to penetrate the microphone when sharp anomalies are nearby. 3. it may also be the noise generated by the operation of the motor or the noise of the electricity, which is generally a normal phenomenon and does not affect the use. 

Detection range: The best distance is 8 m, the maximum distance is 13 metres, 110 degrees. 

The red light of the indicator light is always on: The camera is abnormal or the network is abnormal, Solution: Please long press the reset button of the unit to reset it and try to connect to the network again. The indicator light flashes red slowly: The camera is in network configuration mode, solution: Please try to connect to the network. The indicator light is always blue: The camera is running normally, Solution: Please use the camera The blue light of the indicator lamp flashes slowly: The camera switches to AP network configuration mode or displays a preview, solution: The camera is in a normal state The indicator light flashes red/blue quickly: The camera connects to the network, the solution: The camera is in a normal state 

Operating temperature: -20℃~60℃ (14℉-122℉)