K&F Concept Canada

Enjoy Your Selected Digital Life

Currency: CAD
  • Currency

Log Into Your Account

Account

Order History

Wish List

Register Account

Already have an Account?Log In

  • Shopping Cart

  • Your shopping cart is empty!
  • Favorite

  • Your wish list is empty.

Portable CO Detector 3-in-1 Carbon Monoxide Detector, Alarm Temp/Humidity Detector with Lanyard and Magnetic Suction Function, Mini CO Monitor with 1000mAh Battery, for Home/Travel/Outdoor

SKU: GW40.0008

Q
Is the threshold CO level for triggering the alarm adjustable? Is the volume of the buzzer alarm adjustable, or defeatable?
A
Thank you for contacting us. This portable CO gas monitor can freely set the concentration of the alarm value. The sound can be turned on or off The operation is as follows: In the test interface short press the button to turn off the sound (the default is to turn on the sound at boot), at this time the speaker pattern in the upper left corner of the screen disappears. Short press the button again to turn on the sound again." 
Q
Will this read co2 instantly if we carry it into a greenhouse that has propane heaters?
A
This monitor is only for CO. I don't believe it can detect CO². 
Q
can I use it to see the pollution of CO created by diesel truck to adjust it?
A
No. This is not a high range tailpipe analyzer. This is an ambient air analyzer for worker exposure. 
Q
How often does it have to be calibrated ?
A
Every time it's powered on, it goes through a little 20 second self-calibration routine. You can override it by pressing one of the buttons on the front of the unit. 
Q
Can it be used for cars, exhaust leaks?
A
Any exhaust is going to have carbon monoxide, so yes, it could be used as a leak detector. 
Q
Can you leave this on full time for like a weekend boating & if you do how long will the batteries last?
A
Depends on the battery and after no use it turns off automatically 
Q
How long do the battery's last?
A
I don't know. I sure it depends on how much it is used. I have had mine over a year and working well. 
Q
How do you set the threshold level of CO for triggering the alarm?
A
In the test mode, press and hold the ""MODE"" button to enter the alarm value setting interface: short press the ""°C/°F"" button to switch between numbers, short press the backlight button to edit the value, and then long press the ""MODE"" button to save and exit. The above are the steps of ""Setting the CO threshold level that triggers the alarm"", I hope it will help you! 
Q
What am i doing wrong? it counts down from 120 to 0 then changes modes and sits there. broken? i tried new batteries
A
After the initial countdown it immediately starts measuring CO in parts per million. Mine is very accurate. If yours remains on zero than no CO is detected. If it's doing something weird than maybe it doesn't work. It will not measure CO below 5 ppm eventhough the directs says it will. 
Q
Instructions show how to adjust Indication Level"" digits there is no explanation as to what that means. Can the vendor explain?
A
I am not the vendor but I think that means the CO level that causes the alarm to sound. It is preset at either 20 or 25 ppm and is adjustable.